Wiring Cobra for Minis instead of P90's

[bobogypsy]

I have a hollow cobra special with P90's in it and going to try the Minis.

Currently it has the 3 way togle switch.

What would I need to wire the minis in a 5 way configuration so I can split the coils and does someone have a wiring diagram?

I really don't want to alter the guitar by putting an extra switch in the guitar for splitting the coils.

Thanks,

[taclassic]

I am note sure about the wiring on the Mini pickups, but you could keep the 3 way switch and add either one push-pull (at either the volume or tone control locations) to split both pickups or add 2 push pulls (1 at the volume and 1 at the tone) to split individually.

[tom]

i don't recommend splitting the m1, it's pretty small sounding. the bridge pickup works pretty well split. i'd keep the 3 way and add a pushpull splitter. you'll probably spend more you time on the full sounds.

[bobogypsy]

Thanks Tom,

Can I get the push pull switch from a dealer or through Anderson?

Also can I get a wiring diagram?

I'm not sure about going with the M2 or M3 in the bridge. I play bluesrock R&B and some classic rock where I like a good overdriven sound ( Cream, Stones).

My amp is pretty good for overdrive ( Ceriatone ODS) and clean sounds.
I really like my Heritage 535 with Seth Lovers with this amp.

Would the M2 or M3 be closer to the Lovers in output or sound?

Thanks again.

[bruce]

M2 would be closer... M3 would be farther.